Home Forums EasyTransfer Library Support Forum EasyTransferVirtualWire define pin?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #2443
    Anonymous
    Inactive

    I am trying to use your EasyTransfer library with a 315 MHz rf link – it works fine using a standard virtualwire demo, but I can not figure out how to define the data pin using your library? With just the virtual wire library demo I define int RF_RX_PIN = 2; and   vw_set_rx_pin(RF_RX_PIN);  – not seeing anywhere to specify this pin using your library, have tried using the same method but did not work?

    Sorry if I am missing something, did a lot of searching/testing with no luck

     

    #2449
    Anonymous
    Inactive

    Sorry for the stupid question – I found it by looking at the library itself 🙂 – so used to setting these values in the sketch I did not think to look there…

    Thanks for the library!

    Brent

     

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.