Home › Forums › EasyTransfer Library Support Forum › Serial monitor with ET causes problems › Reply To: Serial monitor with ET causes problems
OK… so the experimentation continues. I did figure out the above, although I didn’t realize that to change to “Serial1” it is also necessary to open that serial port with another line, i.e. Serial1.begin(9600);
Just for a reference, it might be helpful for new guys like myself if that was also in the comments. Since I have basically answered all my questions, maybe this thread can just help other people.
It would be nice to still use the Uno as my master device. Maybe I’ll have to figure out how to use the soft serial library and open another com port on there. However, I’ll probably just end up confusing myself again…
