Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #2815

    Good morning, I apologize for my bad English but I’m using google translate.
    It ‘been a week since I slam my head against my arduino failing to do so go with the wireless controller instead with Joistic cable to go quietly.
    I’m using an Arduino UNO, load the program with arduino1.0.5, the connecting pins are these:

    error = ps2x.config_gamepad (12,10,9,11, true, true);
     / / setup pins and settings: GamePad (clock 12, 10 Command Attention, 9, 11, Pressures?, Rumble?) check for error

    I added a 10K resistor on pin data11, and I’ve tried with both 3.3V and 5V
    it seems that the joystick does not snap to the receiver.



    you tested the control in a video game, this ok? They synchronize?

    When I did my first test, follow these steps. Note that they bind the receiver 3.3v not use R.
    But beware of their Cape Verde, I let loose and he touched the GND, conseguencia lost receiver.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.